Recently, the rain in many places around the country has been continuous after the typhoon, but the work of the loader is still carried out orderly, and the work of the loader is also inconvenient in rainy days. Let's talk about the problems that the loader should pay attention to in rainy days.

　　Point 1: pay attention to the road conditions when working in rainy days, especially in places with thick soil

　　After heavy rain, the soil is wet and slippery. When working in these places, you must pay attention to the surrounding environment and observe it all the time. When pushing the shovel materials, you can use a small throttle to work steadily and do not worry. Because the road is wet and slippery, if the loader bucket is not operated properly or quickly after inserting materials, it is easy to cause wheel slip of the loader. Sometimes the more you can't get in the shovel, the more serious the wheel slip will be. Not only are you dissatisfied with the shovel, but you will also cause damage to the machine. If necessary, you should play a reverse gear and shovel once more.

　　There are also tires. In some places, the upper part of the road is full of mud, but there may be many sharp stones buried underneath. If the tires slip for a long time, it is easy to scratch the tires one by one when they rub against the stones, which will greatly wear the tires at home!

　　Point 2: prevent tire wear

　　If necessary, it is necessary to install anti-skid chains on the loader to increase the safety factor. The installation of anti-skid chains should be carried out in advance. Do not start the installation only when encountering extreme environment, so the installation in a hurry is not safe and troublesome. Secondly, the size of the main anti-skid chain is different, and the size of the wheel hub and wheel width are matched with the size of the anti-skid chain. After installing the anti-skid chain, it should be noted that the loader should not travel too fast, and that sudden acceleration or deceleration should not cause damage to the anti-skid chain.

　　Key point 3: it is particularly important to park the loader in rainy season

　　If possible, it's better to park in the garage, and try to avoid excessive humid environment and choose indoor storage. Rust proof operation is very important. For long-term parking, the machine should be started and driven once a month to charge the battery. After the machine is stored for a long time, the grease on the piston rod should be wiped and the components should be filled with grease. Keep the working device dry and clean during the parking time, and do not get water in, so as to avoid rusting and inconvenient operation of the machine.

　　Point four: it is better to turn the engine part towards the garage when parking in rainy season

　　Some careless drivers think it's OK to put the car in the garage, but they don't notice that the engine part is just under the eaves. When it rains, the water splashes on the engine.

　　Point 5: pay attention to check the filter element of the air filter of the loader in rainy days to prevent rainwater from entering

　　When the used paper filter element is deteriorated, damaged and blocked, it should be replaced and maintained in time; in addition, pay attention to the wear of the sealing ring on the engine oil scale to avoid the wear of the sealing ring that causes rainwater to seep into the engine oil; the oil filler should also be checked, and a plastic bag can be put on when it is necessary to park in the open air, so as to make sure there is no risk. Check the use of starter wire ends to see if they are loose or rusted. If any problem is found, deal with it in time to prevent the starter from being affected by moisture and affecting its service life. Check the use of the generator to prevent the line joints from being affected by moisture and affecting the power generation effect.

　　Key point 6: there is also one of the most common problems in working in rainy season, that is, the bucket is still stuck with mud and cannot shake off

　　When loading and unloading materials, the bucket shall make full use of the limiting block of the working device, and ensure that the bucket has the maximum tilt angle. In order to unload the adhesive in the bucket, the bucket control handle can be operated repeatedly to make the bucket hit the limiting block so that the adhesive in the bucket will fall off due to vibration, but do not hit the limiting block too hard continuously, otherwise it is easy to break the control flexible shaft, The bowl cylinder is damaged.

　　In rainy season, pay attention to windproof, collapse proof, moisture-proof, antiskid, etc. Keep alert when working in the rain, and keep the headlights, work lights, dome lights and instrument light wipers in front and behind the loader working at night to ensure safety.